Compact homemade hydraulic jack stand

Share
Pin
Tweet
Send
Share
Send

In this review, the author shows the manufacturing process of a compact stand for a hydraulic jack. It may come in handy on the farm.

In addition to the bottle jack, profile pipes of different sizes are required (so that one fits tightly into the other), as well as metal blanks and a chain segment.

The first step is to cut out the square base from sheet metal and cut off two pieces of the profile. Drill holes in the pipes.

The main stages of work

The author welds a piece of a profile pipe of a smaller cross section to the base at a right angle, in which four holes must first be drilled with the same pitch.

Then we put on the welded rack a section of a profile pipe of a larger cross section (with one drilled hole). To its lower part you need to weld a piece of the plate.

To the upper part of the profile pipe, the author welds another piece of metal by installing a car jack.

On the sides of the welded top plate, welders from metal scraps must be welded. After that, the master welds a piece of chain along with the locking finger.

At the last stage, it remains only to clean all the details and paint (if desired).

Details on how to make a home-made stand for a hydraulic jack with your own hands can be found in the video on the website.

Share
Pin
Tweet
Send
Share
Send

Watch the video: Wonderful Homemade Jack for Car (December 2024).